US Digital

View the PDF version of this document.

Please note:

• Shown using Polycarbonate Single-ended version.
• These instructions are compatible for all versions of the E5.

• 

  1. Base Mounting

  Secure base to mounting surface using two or three screws. If a centering tool is used, slip it over shaft and into center hole of base. Tighten mounting screws. Remove centering tool.

  ---

• 

  2. Spacer Installation

  Place spacer tool around shaft as shown.

  ---

• 

  3. Codewheel Installation

  Slip codewheel over shaft with mylar disk towards top until it bottoms out against spacer tool. Tighten set screw with hex wrench provided while pressing down on hub.

  ---

• 

  4. Encoder Module Installation

  Slip optical module into position until the two alignment pins slip into holes of module (thick side of module towards bottom). Secure with 4-40 x 1/2" screws (supplied).

  ---

• 

  5. Cover Installation

  Place housing (cover) over assembly and secure with two 4-40 x 5/8" cover screws (supplied).